Open Air Glass Top Risers
Copyright Claim
Open Air Glass Top Risers
Boost
3
14
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
3
14
3
0
31
26
Released
Description
Open air glass top risers.
A lot of the risers out there can cost up to or more than 500g of filament , this entire set of risers is only 45g of filament and prints in 1.5hrs
Raised high enough to keep the ptfe tube from rubbing on the top of the glass and causing damage
I printed in Basic Black PETG and added a Brim to the front riser which was printed on its side, the back 2 risers do not need any brim to print.
The front riser is not my design, I created the back 2 risers from scratch to match the same height of the front riser. The front riser original design is on printable by MG at the link below
https://www.printables.com/model/612992-p1s-lidhood-spacerpropholder
Comment & Rating (3)
All
Pla blue. Thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print and settings. the slot is a little tight though but over all very pleased
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld