Have you ever been a part of a white elephant gift exchange and feel like there should be an award for whoever brings the best white elephant gift?

You're in luck introducing best white elephant gift trophy for whoever brings the best white elephant gift.

Now people will be competing in whoever can bring the best gift instead of who can bring a better prank gift to your next white elephant gift exchange. Add this to your next white elephant gift exchange to add a friendly competition.

This model was designed in SolidWorks.

The trophy is printed in 2 parts the base and white elephant.

The total print time for both of the parts is 1 hour and 15 minutes roughly.

The settings I used are as the follow,

• auto tree support enabled.
• depending on your build plate you may need to add a brim to the elephant but for the most part it turns out fine if you print it without it I did have it fail once though because I did not have a brim, so I recommend adding one.
• The type of build plate I use is a PEI textured but you can definitely use others this is just the only type I have.
• The rest of the settings I just leave as default but if you know more about 3D printing than I do let me know what you did if it turned out better.

The assembly is pretty straightforward there's a pin on the base and a hole on the bottom of the elephant and have been designed to fit.

I had just a little bit of glue inside of the hole on the bottom of the elephant and then insert the base and adjust to liking.

I can only 3D print in one color at a time so all I did just take a sharpie and just color pupils of eyes very carefully and it stayed on pretty well, but you can leave it just white if you want.

I'm pretty new to 3D printing and model design, so if you have any suggestions, please leave them in the comment section below.