Bambu Lab Extruder Entrance PTFE Guide Pullout - ★ FIX ★ Failed to pull back the filament to AMS
Remixed by
Copyright Claim
Bambu Lab Extruder Entrance PTFE Guide Pullout - ★ FIX ★ Failed to pull back the filament to AMS
Remixed by
Boost
12
27
16
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
17 min
1 plate
0.2mm layer, 6 walls, 25% infill
21 min
1 plate
Boost
12
27
16
0
88
46
Released
Description
This attachment fixes the “Failed to pull back the filament to AMS” error.
I loved the concept behind @TheTexMech original version but I want a fan of the process used to design it or the end result. So I went ahead and designed this remix from the ground up using measurements from the original as a template.
With the “wings” to the side of the printer slide the bottom of the attachment over the top of the extruder. Rotate the higher tab to the rear so that it cannot hit the case.
Print in PETG or some other heat resistant material.
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like and ★ Rate!
Comment & Rating (16)
All
Where can I get my prusameters as you said in the model description? 😂
1
Reply
I've used a few of these - this one doesn't break off. :-) It also seems to work, which not all of them do. Also CF-PETg - I'll update if I have issues too.
0
Reply
AWESOME!
First PTFE / Filament guide that worked for me! Also the easiest to install. Thanks so much!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
printed well - PTG
0
Reply
Just wanted to post a quick update, printed this awhile ago in CF-PETG was working great but seemed to wear out, the collar no longer is tight with and moves which started causing pull back errors again.
Will try and print again in ASA I thought PETG would be fine guess not :-D
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
simple, strong and to the point. did mine in matte green for contrast, same as my other bambu mods.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Works great solved the problem. thanks
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
sehr guter petfe cube , geht top zu Drucken, mit Generic pla , ohne stützen.habe Mein Profil genomen , p1S gedruckt. thanks
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld