Tardis Dice Tower /w Tray
Copyright Claim
Tardis Dice Tower /w Tray
Boost
35
99
8
Print Profile(2)
0.2mm layer, 2 walls, 8% infill
Designer
25.1 h
1 plate
0.2mm layer, 2 walls, 8% infill
Designer
27.7 h
1 plate
Boost
35
99
8
0
98
26
Released
Description
This TARDIS dice tower should easily accomadate standard D20 dices and I hope you enjoy it. I had fun making it.
Comment & Rating (8)
All
PRINTED AMAZING!!! My daughter was so psyched to get this. I slowed to 50% to get a good based then went back to normal speed after. 38 hours print time with the speed changes.
Thanks for putting the files up. 😁
0
Reply
What is the tower on the back for? It seems like a lot of waste to me
0
Reply
it's the purge tower because it was printed in 2 filaments. turning it off risks some of the white bleeding into the blue and vice versa. I think turning it off is worth the saved waste. Especially on a model that's mostly primitives.
1
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
overhangs could have used some support
The designer has replied
0
Reply
Thanks for the suggestion, my printer is usually pretty tuned so I typically dont need supports for small overhangs, but I did add a profile for that just in case.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
I wasnt thinking and chose supports on the first print. Had to reprint it
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
Other Issues:lost power and the print failed
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld