Otf Fidget toy
Remixed by
Copyright Claim
Otf Fidget toy
Remixed by
Boost
11
11
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
2 plates
Boost
11
11
6
0
70
38
Released
Description
(no rubber band) FULLY PRINTABLE Otf Fidget Toy
for mount;
https://www.printables.com/fr/model/664268-no-rubber-band-fully-printable-otf-fidget-toy
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well on full speed
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print but doesnt pop out very well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good print didd'nt come out too bad, although the spring could do with a bit of strengthening as it was'nt always popping out the blade ok.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue
0
Reply
A bed adhesion issue is not the fault of the designer.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:I have printed my 2nd one and still can’t get it to work! So so hard to put together. My X1C printed it extremely well but I just couldn’t get it to work.
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld