These devil horns are made to be attached to a headset.

The .stl file is one single horn.

The .3mf file is for Bambu Studio and already includes two horns on the build plate.

Print Settings:

I printed the horns with 0,12 mm layer height and no supports which works fine for me.

However, you can automatically generate support structures if you want to. When I did that the print came out fine too but I sometimes had to file down sharp edges left from the support.

Also I changed the infill pattern to gyroid and set the seam position to nearest.

Assembly:

To be able to attach the horn you can order velcro cable ties from Amazon.

Just simply put a velcro cable tie through each of the horns and wrap it around the top part of your headset.