Looks great and works well!
The clearance for the door and the channel is just right. The supports are essential although I did have a few filament lines not adhere on the inside. I just pulled them off, you can't really tell and it doesn't affect operation. If it was really important I could clean them up with a knife.
I printed this in IEMAI silver/blue silk PLA, it looks great. They're holding lots of crochet stitch markers here.
Thank you for the model!
Support Issue:The opening for the lid is an unsupported overhang and did not survive the print. Otherwise very cute little box that we’re using for the tooth fairy/underpillow successfully.
As you can see in my photos. It can print just fine. Will come down to your printer. It's prints this just fine on my Bambu P1S which can deal with overhangs like this.