Earring Box
Copyright Claim
Earring Box
Boost
89
134
62
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
A1 Mini: 0.2mm layer, 3 walls, 15% infill
48 min
1 plate
0.2mm layer, 3 walls, 15% infill, with supports
48 min
1 plate
Boost
89
134
62
0
439
432
Released
Description
Very small jewelry box used for storing earrings. Can store other small items also.
Lid slides in through slot with small notch to allow for easy opening of the lid.
5.5cm x 5.5cm
Comment & Rating (62)
All
A1 mini, used the profile I posted above.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great design but small. can you make bigger box?
The designer has replied
0
Reply
I would think you should be able to scale it up in the slicer. Have you tried that?
(Edited)2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Epic
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it’s ok but with a little change is posible to improve the print without supports.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:The opening for the lid is an unsupported overhang and did not survive the print. Otherwise very cute little box that we’re using for the tooth fairy/underpillow successfully.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Lol just prints the top lip part mid air, cool waste of time that doesn't expose itself until the last 2 minutes.
The designer has replied
1
Reply
As you can see in my photos. It can print just fine. Will come down to your printer. It's prints this just fine on my Bambu P1S which can deal with overhangs like this.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Edited because I was asked for a review after several other prints. The profile for the box worked great 👍🏾
(Edited)The designer has replied
0
Reply
The picture you've posted does not reflect the design.
0
Reply
Replying to @braden.manning
Oh, I'm sorry. I thought it was asking about the print in the picture
0
Reply
Print Profile
A1 Mini: 0.2mm layer, 3 walls, 15% infill
Cute little box, quick prin too!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Simple print. Scales up nicely. I do recommend enabling supports.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
recommend
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld