HSW Filament Flush Cut Pliers Holder
Remixed by
Copyright Claim
HSW Filament Flush Cut Pliers Holder
Remixed by
Boost
48
134
28
Print Profile(1)
0.28mm layer, 4 walls, 15% infill
Designer
19 min
1 plate
Boost
48
134
28
0
224
150
Released
Description
- simple insert to fit universal flush cut pliers for filament cutting etc.
- use with blank insert_hollow from the original HSW board
Printing instructions:
- no supports
- use 4 perimeters
- layer height pictured is 0,2mm
Version history:
v1.0
19.10.2023
- initial release
Comment & Rating (28)
All
Print Profile
0.28mm layer, 4 walls, 15% infill
une place pour chaque chose, rapide à imprimer, pourquoi s'en priver 😁
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
Simple, effective! Thank you.
The designer has replied
0
Reply
thanks!!
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
passt perfekt
The designer has replied
0
Reply
thanks, check out my other HSW additions :)
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
little small for adapter
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
printed @102%
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
i printed like 4 of these very slim but hold up good so far
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
fits perfect
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
great quality
0
Reply
Too weak for normal use. Bad design. Don't waste your plastic and time on this.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld