Print Profile(2)
Adaptive layer, 3 walls, 15% infill
Designer
52 min
1 plate
0.2mm layer, 2 walls, 30% infill
Designer
1.7 h
1 plate
Boost
18
33
20
0
104
95
Released
Description
Cute and easy-to-print doorstop in the shape of a slice of cheese.
For best results, I recommend using the adaptive layers as shown in the attached photo.
I have always made it in PLA but it is possible to make it in any material.
Maybe TPU is the better solution
Comment & Rating (20)
All
My golden Cheese, :-)
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
I printed this twice, in white PLA it looks too thin but when I used yellow it looked way better. the corner is a bit sharp but works great
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
it's a cheese wedge and it works! prints easily and looks great! huge laugh at the office.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
molto utile e bello esteticamente
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
sometimes, I dream about cheese
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
printed to keep cats door open. wife loved it
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
funny and fuctional
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
0
Reply
Print Profile
Adaptive layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld