Record player, Amp & Mixer. playset / secret draws

A play model of a HI-FI with a "technics 1210" , Amplifiers and a mixer.
The Amps and Mixer are made to be draws.

The record player was designed to play licorice records (candy).
Scaled so the licorice is about a 7 inch record.

The knobs on the Amp can turn but the knobs on the mixer are static.

Some glue is required.

TEKNICS1210 : all quite simple to print and stick together, print 4 feet and 2 speed buttons. The plate will rotate (if you dont glue it) .
The arm is in 2 halves - held together with the head and the weight.
assemble the arm and glue it on the pivot.
Depending on your tolerances/temps/filament some parts maybe press fit.

AMPS & MIXER : There are 3 main parts, shell, draw & backplate.
The shell (Mini Amp (1)) has a lip on the inside, this is the front.
I put the draw into the shell and then glue the back plate onto the draw. This prevents the draw from pulling all the way out (the lip on the shell will prevent the back plate from sliding all the way out).

This is of course up to you - the piece is decorative on its own and if you dont want to use it as draws for your stash - then the back plate is not required.

The big knob for the AMP comes in 2 versions. Both versions are in 3 parts. Mark 2 was intended to be a "glue free" version but if you are going to use it as a draw handle - then some glue is probably needed.

Any questions on assembly - feel free to contact me :)
Enjoy

No supports required. Just make sure your bed is level.
Some of these parts are 12 hour prints (on an ender 5).