Red Bull cap - snap on
Red Bull cap - snap on
Boost
39
65
20
GIF
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
19 min
1 plate
0.2mm layer, 2 walls, 15% infill
18 min
1 plate
Boost
39
65
20
1
115
106
Released
Description
This is my third can cap.
This time for the Red Bull cans (the width is slightly different).
Print in different colours to have a easy marker. You will always know, which can is yours.
It just snaps on your can and helps to prevent, whatever it is, to get into your open can.
Hope you like it.
Comment & Rating (20)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Works as intended. Thanks
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
belle impression, parfaite en taille
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
fonctionne parfaitement 👍
0
Reply
we need one for a 16 and 20 oz redbull
The designer has replied
0
Reply
I will try to get these sizes in Germany
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
will do more of them thank you again
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt genau
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
gracias por tu aporte
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld