Jewelery Holder for Necklace, Ring, and Earring
Boost
52
88
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Boost
52
88
3
0
60
20
Released
Description
The pieces snap together when held at a 90 degree angle from each other as shown in the last picture. Every other one should be rotated 180 degrees.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed a load of support for no reason
very flimsy
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:there were extra unnecessary supports throughout the entire print
Strength Issue:the model was too flimsy and ended up breaking while taking off the supports.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld