Cracked Dragon Egg Bowl
Copyright Claim
Cracked Dragon Egg Bowl
Boost
12
31
5
Print Profile(2)
Multi-colored 0.2mm layer, 3 walls, 5% infill
Designer
11.9 h
1 plate
Single Colour 0.2mm layer, 3 walls, 5% infill
Designer
3.4 h
1 plate
Boost
12
31
5
1
32
17
Released
Description
Can be printed with 2 walls… But 3 give more strength
Also 5% infill works well. Increase for more strength
For Commercial Rights To This Model:
https://www.patreon.com/Tri_3D
Comment & Rating (5)
All
Print Profile
Multi-colored 0.2mm layer, 3 walls, 5% infill
Had some troubles with purge and color change, but can't confirm if it is due to the profile or some other error...
(Edited)
The designer has replied
0
Reply
What machine was this printed on?
The profile does have very low Purge time to cut print time down.
But iv never had an issue on my P1S.
This issue has given me a new idea though.
Ima look into making the scales a sleeve to fit around my normal eeg design.
So it wont need an ams
Thanks for bringing this to my attention
(Edited)0
Reply
Replying to @Tri3D
P1S, and I couldnt figure out why it happened 😅 do you think you can get it to a gradient? 😅
0
Reply
Print Profile
Multi-colored 0.2mm layer, 3 walls, 5% infill
Nice clean print.
0
Reply
Print Profile
Single Colour 0.2mm layer, 3 walls, 5% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld