Top glass riser for P1S and X1C
Copyright Claim
Top glass riser for P1S and X1C
Boost
86
174
57
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
35 min
1 plate
PLA 0.2mm layer, 2 walls, 15% infill Gyroid
30 min
1 plate
Boost
86
174
57
6
461
287
Released
Description
Cleanest and most simple top glass riser out there (in my opinion). No support necessary, 15% Infill, quick and easy print.
For the P1S, likely also works on the X1C.
Comment & Rating (57)
All
Perfect! It does just what is needed to hold the top glass open to vent. A quick print.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
quite good
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
:)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
work great. Thank you
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Great print!
0
Reply
Very Nice
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
very nice
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
came out perfect and works as intended
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld