This unique Print-in-Place keychain can hold your phone upright or sideways so you can watch videos on the go. Prints in under 40 minutes with no supports and is ready to use straight off the printer. The snap in design is satisfying and functional. The tolerances are 0.3 mm (Added 0.4 and 0.5 mm tol) however, if your printer cannot print that tight you can just scale the model up until it can. I personally use this daily so I thought I would share it with you all :) (took me days to perfect). If you want to sell these, you can use the link below.

Commercial Use: https://cults3d.com/:1242543