Leave on_Filament Clip
Copyright Claim
Leave on_Filament Clip
Boost
21
31
7
GIF
Print Profile(1)
0.24mm layer, 2 walls, 20% infill
Designer
16 min
1 plate
Boost
21
31
7
0
32
28
Released
Description
Flow Clip "Leave on" Filament Clip
Design #7 Flow Clip.
I wanted a filament clip that I could leave attached to the spool when in use. It had to allow the spool to spin freely inside the AMS system, and it couldn't interfere with the AMS feeder. Enjoy!
Details:
- Clip can be left attached to the filament when in use. Works with the AMS system, and likely any spool holder as well
- Falls off inside the AMS bay when filament runs out. Pick it up and slap it on the next roll
- Does not interfere when stacking filament
- Uses less than 2grams of filament
let me know how it works out for you. I've ran this setup for a little while with no issues, but your miles may vary.
If you like this design, maybe check out a couple of my others below 👇
https://makerworld.com/en/models/238354#profileId-254240
https://makerworld.com/en/models/220617#profileId-239114
Comment & Rating (7)
All
Print Profile
0.24mm layer, 2 walls, 20% infill
would be loose over time, but great design anyway
The designer has replied
1
Reply
Yea, definitely a consumable 👍Thanks for the comment and rating 😁
(Edited)1
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
Printed just fine... how ever using it was more of a problem,
The designer has replied
0
Reply
Thanks for the comment. What types of problems were you experiencing?
(Edited)1
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
they print out fine but since i started using them they repeatedly cause the spools to get stuck and I had to remove them.
(Edited)0
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
Model printed well, but have some issues getting it to keep the filament from unwinding around the spool. Maybe I am just installing it incorrectly
0
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld