1x1 Legos-Brick Part:6541 by hollowmaker

hollowmaker

Toys & Games>Other Toys & Games

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm nozzle

Designer

26 min

1 plate

5.0(1)

0.4mm nozzle

Designer

12 min

1 plate

Boost

Released

Description

Technik Brick 1x1 with hole

Item No. 6541

Also check out my other Legos compatible designs I have made:

Follow me to stay updated and never miss out on my latest exciting creations! Thank you :)

Comment & Rating (7)

@Inti3s

Print Profile

0.2mm nozzle

Profile prints well. I tried this with a 0.4 nozzle and no supports and no issues in tern of printing. However, may have to work a bit more in the scaling as botton fits right, axle hole about right, but top stud is too big (doesn't fit **official** bricks)

The designer has replied

@hollowmaker

Thank you for the valuable feedback. I actually only printed this part once using a 0.2mm nozzle and PolyTerra PLA and didn't notice any problems. I will check on this and get back to you. Thank you for printing my files :-)

@hollowmaker

I printed the model with a 0.4mm nozzle and Elegoo PLA+ and couldn't find any significant defects. However, I recommend using a smaller nozzle for such small parts. What filament did you try it with?

@Inti3s

thanks for checking this out. I’m using BL PLA Basic. I’ll give it another shot later today, as I had an issue with another piece using same filament. It’s also likely shrinkage/scaling may be a factor on my end

(Edited)