Couch Buddy!

_______________________________________________

About:

Tired of getting stuck in the middle of the couch with no place to set your soda can. Problem solved with Couch Buddy! Print, insert friction fit slats into the bottom, place between couch cushions, open a soda, start a movie and enjoy.

Now check out Couch Buddy Pro! Added slot to hold phone or tablet.  Switch which holes the slats go in to make Couch Buddy Pro right or left handed.

Also check out our can dispenser for your fridge.

____________________________________________

Steps To Print:

1. Print both plates using the 3mf files
2. slide the two slats into the holder and set it in your couch

____________________________________________

Dimensions + Print Time + Filament Used:

• 150mm wide
• 50mm tall
• 4 hour 30 minute print time
• 200g of filament used

____________________________________________

Settings:

• Layer height: .28
• Walls: 2
• Top shell layers: 3
• Bottom shell layers: 2
• Infill: 10%

_____________________________________________

Extra:

Can Dispencer: Can Dispenser (1 Print) by mwiller - MakerWorld

More Cool Prints:mwiller | Published - MakerWorld