This project is super Cool! Nanoleaf Lines but at a fraction of the cost. and there is NO SOLDERING involved
Parts List
- BTF-Lighting WS2812B Eco 300LED 5M: US | UK | CA | DE | FR
- Aluminium Led Diffuser Channel Shallow w. Mily Cover: US | UK | CA | DE | FR
- 3D Printed Connector Piece (in Files)
- Nano Gel Tape(Try to find in Hardware Store): US | UK | CA | DE | FR
- Cable Channel (Try to find in Hardware Store): US | UK | CA | DE | FR
- IKEA KUGGIS Cable Box: US | UK | CA | DE | FR
- Arduino Uno R3: US | UK | CA | DE | FR
- 400 tie Point Breadboard MB-102: US | UK | CA | DE | FR
- Dupont Wires Assorted Kit: US | UK | CA | DE | FR
- (OPTIONAL) Hook-up Wires 28AWG: US | UK | CA | DE | FR
- 100uf-1000uf Capacitor: US | UK | CA | DE | FR
- 220-440 ohm Resistor: US | UK | CA | DE | FR
- Terminal Block (ONLY FOR NORMAL SIZE PSU): US | UK | CA | DE | FR
- 5V Power Supply (Amps = LEDs x 0,06)
--------- Normal Size (Up to 10A): US | UK | CA | DE | FR
--------- Full Size (Up to 50A): US | UK | CA | DE | FR - Power Supply Cable
--------- For Normal Size: US | UK | CA | DE | FR
--------- For Full Size: US | UK | CA | DE | FR
Circuit Setup
Animations
https://youtu.be/w8k6eex0uW8
CODE
View in Files
HOW TO SET UP
- Cut your LED Profiles to Size with any Saw
- Click a Connector Piece to a LED Profile and feed the LED Strip through the Connector Piece and repeat until design is done
- Connect components together by looking at Circuit setup and put in cable box
- Install Cable Channels on the wall without Covers
- Connect Hook-Up Wires or M-F Dupont Cables to Extension Cables
- Put Cables in Cable Channel
- Put Nano Gel Tape on Connector Pieces, and Install on the wall
- Connect Night Strip to Hook-up Wires
- Put Cable Channel Covers On
- Plug In Power Cable
- Project Should Light Up