I just edited it so a 2 Euro Cent coin could fit
I haven't yet printed it but I will and put up a picture
There are these little teeth there that should help hold the coin
Although they are just there because I was too lazy to remove them
Use the "Drunk Domo Key Chain 2EUROCENT_2" Version
It's the one with the higher quality and the actual size
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15
white
Notes:
It's a pretty easy print
the only problem that could occure is the bridgeing on the upper half of the coin-slot
did not test it yet, but will.