Ace of Spades | Charged up | Fire | Gambit | X-Men by LTB-3D

LTB-3D

Toys & Games>Other Toys & Games

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.4 h

1 plate

4.0(3)

Two top layers of white at 0.2mm layer height

Designer

1.4 h

1 plate

Boost

Released

Description

Inspired by Gambit from the X-Men, here is an Ace of Spades that is charged up, flaming, or on fire.

Also pictured:

https://makerworld.com/en/models/136411

https://makerworld.com/en/models/132647

PRINTING NOTE:

At .2mm layer height, you get 2 top layers of white printing over the red. This allow a small potion of the red to show through as intended. If you adjust the layer height or or use a white filament that more translucent, it will impact the opacity.

Comment & Rating (5)

@wadeido3715

Print Profile

0.2mm layer, 2 walls, 15% infill

it came out great no issues printing. Thanks for sharing this will be a nice addition to my xmen collection

The designer has replied

@LTB3D

Your print looks awesome! Thanks for posting a picture.

(Edited)

@Ron_Solo

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:too much bleed through, top layer is too thin.

The designer has replied

@LTB3D

Hello. I'm sorry that your print came out poorly. This was designed to have a small amount of visible "bleed through". Based on your picture, I would say try a different WHITE color filament. I've had issues in the past with certain brands of whites filament not being opaque enough. Or maybe verify the layer height. At .2mm layer height, you get 2 top layers of white printing over the red. If you adjust the layer height or or use a white filament that more translucent, it will impact the opacity. As you can see from the pictures that others have posted, a nice print is possible with the specified layers. Please follow up if you try again. I want to make sure you get a nice result. Thanks!

(Edited)