Flies slower and more accurately than v2, at the cost of reliability and build difficulty. Is more durable and can be modified more.
Print with 100% infill in PLA. A brim isn't needed.
Wait until the build plate is cool before removing the glider to prevent bending.
Fold the back wings 90 degrees towards the flat side of the glider.
Fold the elevators around 45 degrees towards the flat side of the glider.
Fold the main wings up around 30 degrees towards the flat side of the glider.
Refer to the thumbnail to make sure that the glider is adjusted properly.
Throw the glider with the elevators facing up. If it veers to the side and falls out of the air, bend the main wings up slightly. If it doesn't fly far before hitting the ground, bend the elevators up. If that doesn't work, bend the main wings down slightly.