Simple P1S Glass top lifter (1.5g of filament!)
Copyright Claim
Simple P1S Glass top lifter (1.5g of filament!)
Boost
4
5
6
Print Profile(2)
0.28mm layer, 3 walls, 15% infill
Designer
14 min
1 plate
Bambu PLA tough
Designer
12 min
1 plate
Boost
4
5
6
0
19
19
Released
Description
If you are printing PLA or filaments that require open air to reduce heat build up in the chamber, then you will like this mod!
1.5 grams of filament for this little glass lifter. 15 minutes to print with prep time.
- -designed to fit into the little hole around the foam
- -when not using, it can be fitted on the top slot for P1S/P1P with enclosure upgrade
- -designed to reduced use of filament/waste
Comment & Rating (6)
All
Print Profile
0.28mm layer, 3 walls, 15% infill
Perfect, very useful
The designer has replied
1
Reply
glad that you like it!
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld