Print Profile(3)
0.2mm layer, 2 walls, 35% infill
Designer
7.9 h
1 plate
0.16mm layer, 2 walls, 35% infill
Designer
9.1 h
1 plate
0.2mm layer, 2 walls, 35% infill
Designer
41.5 h
1 plate
Boost
48
55
8
1
91
23
Released
Description
Please consider supporting me with a boost on the new system, would love to have more recourses available to make and share Models!!
please check the filament flushing volume before printing
DOOHH!!!
Homer is now official gaming with you!!!
Comment & Rating (8)
All
I usesed the pre colored and mine came out like this
The designer has replied
2
Reply
you need to tune your flushing volume. from black to yellow is normally quite high for all the black to go away .
regards
0
Reply
Replying to @eenig3d
I had the same problem here.. very unfortunate to waste so much filament.
What are your flushing settings and how to test properly?
(Edited)
1
Reply
Replying to @nugat.p
thanks for the reply. I will go tru all the profiles when I have the time. thanks for feedback mate and sorry for the waste.
(Edited)0
Reply
I would go 3 walls it's very flimsy
The designer has replied
0
Reply
You can always change it to 3 walls if you like in the slicer, my experience was it was normal stable with 2 walls. also keeps the filament usage down.
Regards.
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 35% infill
Top geworden
1
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
1
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld