Both sides are included and orientated correctly. Just print at any resolution in any material you want. Please let me know if you need any help or have any suggestions.

I did not like any of the existing adapters, so I created this. It is super sturdy and allows for forward backward adjustment. You can use it as show, or replace the back of the BoboVR with the Solo Knit Band. You can use it with or without the light shield. They easily clip on and off of the Vision Pro, and slide into the BoboVR with a nice friction fit. If anyone has questions or comments, just let me know!

ADDED:
I added an adapter to attach the Solo Knit Band to the BoboVR instead of the Apple Vision Pro. These may be a little tricky to print, since it will require support. These use the original hardware, including the while plastic cover, screw, and o-ring. They should be strong enough since the white cap supports the inside of the plastic tabs. Print a little hotter with less fan to get better layer adhesion for the small tabs. My prints are strong enough, but test before risking your $4000 device!!!

They are directional, notice the alignment tab. That should go up to get the indents to keep the band at 180 degrees. I offset the connection for the band so you should be able to get some adjustment by flipping right and left.. You may need a smaller band, but try with your original band first.

ADDED #2:
Included pads you can print to put on the Apple Vision Pro band attachment point, just in case they touch your head. Add some felt to the pad and you will have a soft interface for your head.

ADDED #3:
Shorter rails that are quicker to print and move the BoboVR lower allowing more angle to use the Solo Knit Band

It's super comfy and feels almost weightless. I have been using this all day for a while and am super happy! Let me know if you have any suggestions or issues! Good luck and enjoy.