Hueforge - Queen II Album Cover by Cloudy Nostalgia

Cloudy Nostalgia

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 2 walls, 100% infill

Designer

4.5 h

1 plate

Boost

Released

Description

This model does not print nicely when using bambu beige. It comes out too white. For best results be sure to use the Sunlu Skin Beige. If you do not have access to that I made another model with different filaments.

https://makerworld.com/en/models/418235#profileId-320783

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Orange Transmission Distance: 5
PLA Sunlu Skin Beige Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #16 (1.36mm) swap to Orange
At layer #19 (1.6mm) swap to Beige
At layer #30 (2.48mm) swap to Jade White for the rest.

Comment & Rating (6)

@little_airwolf

Awesome

The designer has replied

@cloudynostalgia

Did you print that frame also? Thats amazing! do you have the file on your profile?

@elisir

bonjour,le blanc il ne s'affiche pas dans mon AMS et je ne comprends pas pourquoi 😭 les 3 couleur ils y sont sauf le blanc. qu'est ce que ça pourrait être ?merci d'avance

The designer has replied

@cloudynostalgia

Can you add a photo of your issue?! maybe I can help with that!

@elisir

premier photo le blanc il y est et deuxième non,donc du coup il n'apparaisse pas dans le slot AMS . ☹️

@cloudynostalgia

Replying to @elisir :

So sorry ! I didnt see your message! did you happen to rescale the image? It looks like maybe you made it smaller to fit a smaller print bed and maybe the z height also got smaller. If thats the case it would run out of layer heights before it got to white. When resizing the image try instead turning off "uniform scale" and then adjust ONLY x and y to the same percentages. Do not change the Z.