Updates for Version 2 (This applies to all hammers):

1. Hammer now has been smoothed and no longer has a line down the middle of the hammer head.
2. Handle holder has now been lengthened to hold more of the handle to be more sturdy.
3. Top accent wording has been completely re-done in blender and enhanced. No more bleed through and easier to read. 
4. Every Hammer now has an alternate Top accent with “She who wields”.

Go check out the other NFL Thor Hammers on my page! Thors Hammer like you never seen it before. Transformed into the Ultimate NFL football accessory. It's easy to print and with a little super glue you are all set. Separated into 4 plates for easy and fast printing. Perfect size too!! If you want to change anything, just use the files in Bambu slicer and change what you want. I recommend gorilla super gel or E6000 to put the parts together. 

Instructions: Pull out the support on the hammer head block with needle nose pliers. Glue the Long handle into the pummel. Then glue the handle into the holder. Put superglue on the handle holder rim and then push it into the hammer head block. (It will be a tight fit) I recommend lightly sanding the parts that are glued for faster and easier adhesion. Glue the accent on the top and lastly glue the 2 logos on each Front side. If you so choose, add the jersey number of your choice on the sides with the other print profile labeled Jersey Numbers. Enjoy.

Logo instruction: 2 Plates have different logo colors for a reason. One is if you have 2 or more AMS units, and the other is if you have 1 AMS. If you have 1 AMS like I do you, you will have to change filaments 2 times on different layers. I added pauses on the 12th and the 14th layer for the changes. Start with White, black, yellow and red. On the 12th layer (first pause) Change out the white for blue. On the 14th layer (2nd pause) change out the black for silver (or grey if you dont have have it). Before you resume after the silver change, make sure you set your speed to SILENT. This is because the silver filament needs to be printed a lot slower. If you are using grey, then you can print normally.

If you like my stuff, visit my Patreon at Cosmic 3D Prints | Hyper fixation is awesome! | Patreon

Or if you would like to buy me a coffee, go here Mike (buymeacoffee.com)