Cable chain end caps for IGUS 16mm chain (Rev2)

What is this?

Durable and long-lasting end caps for famous IGUS 16mm cable chain used in Voron Trident, Voron 2.4 and (some) Voron Switchwire builds.

Fast to print. No print supports needed.

Male and female models.

Recommended print settings:

• Layer height: 0.2mm
• Extrusion width: 0.4mm, forced
• Infill percentage: 99%, rectilinear
• Walls: 4
• Solid top/bottom layers: 5
• Supports: None

Recommended filaments:

• ASA, ASA-CF, ABS, ABS-CF
• PETG, PETG-CF will be OK for non-enclosed printers only;
• PLA, PLA-CF, PLA-tough(and alike) are not recommended due to relatively low temperature resistance.