USP-S SILENCER - COUNTER-STRIKE 2 - AIRSOFT REPLICA 3D print model

I designed a replica model of the USP-S Silencer from CS2. The thread is spaced so it fits perfectly on the desired airsoft gun with either 11ccw or 14ccw.

Whats included:

• USP-S Silencer 11 CCW
• USP-S Silencer 14 CCW
• USP-S Silencer Hex Patterned 14 CCW

Instructions: You can use the hole on the right side for a screw and hex nut, to make the silencer not move. But you can also use it without.

What you will need:

• 1x M3 Hex Nut
• 1x M3 Screw 8mm - 10 mm

Just put the Hex Nut in the bottom compartment and screw the screw inside. Thats it!

Recommended print settings:

• 0.2 Layer height
• Brim
• Flip the Model 180 degrees

I also recommend using PET or PETG filament if used outside for better UV-protection.