Wall Shelf 3D print model

YouTube short here: https://rb.gy/c3mr9

Originally designed to be a shelf for nail polish. Can fit most standard nail polish bottle sizes. A combined strip can house 10-14 bottles depending on the bottle sizes. Grooves in back are modeled for 0.75" double sided foam tape (3M brand is what I used, can be found in hardware stores or online). Left and right sections slot together loosely. You should apply two tape strips to left side, two strips to right side, peel all adhesive masking, slot pieces together, then stick to wall together. Press for about 30 sec.

**Be sure to measure and mark the wall for the shelves to be straight. You don't want anything sliding! **The tape is SUPER strong, so make sure you have the shelf right where you want it.

Bear with the crazy measurements: Left shelf piece is 7.9375(201.6125mm) wide, 1.7076 (43.37304mm) deep, and 3.00095(76.22413mm) high Right shelf piece is 7.82878 (198.851012mm) wide, 1.7076(43.37304mm) deep, and 3.00095 (76.22413mm) high Combined shelf is 15.625" (396.875mm) wide

Print with back grooves facing down. Support needed only for the little tab on the left piece.