Gloomhaven Player Dashboard & Storage Case
$1.99 Gloomhaven Player Dashboard & Storage Case
Published 2021-07-26T08:56:47+00:00
***BEST FOR A FDM (FILAMENT) PRINTER ONLY***
I didn't like any other dashboards around for Gloomhaven, so I made my own. This time, blending both a storage solution, and a comprehensive Dashboard to keep track of all your bits! Check out the link for a video of it in use!
https://www.etsy.com/uk/listing/1036838247/ultimate-gloomhaven-player-dashboard
The "Caracter box V2.stl" houses everything from the mini to the tokens, with enough slots and holes to use in any way you feel more comfortable. The player card being used as the table on which you set your cards out as pictured, the two slots either side that act as holders for your discard/lost cards and then the top part of the tray being used for active cards that round. I've created a small dish for the players tokens, a slightly larger one for extra tokens/summons/coins and then 3 slotted recesses for active effects on the player, like muddled or stunned.
The "Dashboard top v5.stl" slides into place and locks with friction fit to prevent the small pieces escaping, Apply a tiny amount of grease or lube of your choice on the sides and it will slide in perfectly. The lid can also be used to display items, collect coins and hold the modifier deck.
The "pull out modifier deck.stl" is just a simple solution and a place to keep the modifiers, i personally like to place it on the lid after unpacking.
I print the dashboard with a 0.4 nozzle at 0.25 layer height.
It has by far been one of the best upgrades for Gloomhaven i have made, alongside my custom health counter shown in the pictures. Pull this Dashboard out and be setup in under 30 seconds! The cardboard boxes that the characters come in are fine, but not meant for repeated use.
As a BONUS i've included a custom health tracker, it can be a bit fiddly to print, but low layer heights and slower print speeds help :)
Assemble the Health counter by printing 1 Cradle, 4x Wheels.
Then pop the wheels into the cradle with the cut outs of the wheels facing the small bumps on the crade,
then thread a small section of filament (1.75mm) through the wheels and cradle holes, you may have to run a 2mm drill
down the centre of the holes depending on the tolerance of your printer. Snp off the end of the filament flush, and dab with a tiny amount of super glue to stop the filament working its way out.
I print the health counter with a 0.4 nozzle at 0.1 layer height.
If you dont have an FDM printer, I sell this physicaly on my Etsy store here:
https://www.etsy.com/uk/listing/1036838247/ultimate-gloomhaven-player-dashboard
Date published | 26/07/2021 |
Price | $1.99 |
Support Free | YES |