Picase Pi Case

Picase is a modular enclosure for Raspberry PI and computers of the same form factor (Rock Pi, Asus Tinker board,...).
It is designed to accommodate the most common additional accessories and make them easily accessible and removable.

Picase has been extensively tested for 6 months now both indoors and outdoors

Please leave a comment if there's any specific accessory or it can be further optimized for your device of the same form factor, I would like such design to accommodate more users and such mini computers.

COVER part can be customized with available infill textures when top/bottom layers are set to 0. It's flat surface allows users to customize it and brand according to their own needs.

Notice:
Bottom + has plus-shaped holes so that it can be attached to walls. Top for 3.5 touchscreen is designed only for that specific accessory. Please print only the bottom part first to make sure that your printer is well calibrated, the device and other parts should snap with slight pressure to it. Optionally, you can heat the bottom part to slightly bend it in order to fit other parts.
Its snap-fit design enables it to be easily assembled and disassembled while a few drops of glue can make it permanently assembled if needed.

Transparent version displayed in photos will be available for SLA 3D printers in a few weeks.

Designed for 0.4 nozzle. recommended to print 1 by 1 to get most of surface quality

PLA settings:
Printing speed: 50mm/s
First layer speed: 30-50% (adjust manually if needed)
Nozzle temperature: 215
Fan speed: 100%
Wall line count: 3
Bed temperature: 50+
Top/Bottom layers: 5+
Infill: 20+
Z seam: aligned to sharpest corner and smart hiding if available