CyberBase System Shockwave Tower 3D print model

And here we go with the second part which sits atop the earlier Space Bridge Elevator piece (https://www.patreon.com/posts/cyberbase-system-34735568)!

Appearing in one of the earliest segments in the pilot series, this was where Shockwave first appeared as he was instructed by Megatron to remain on Cybertron the ensure that nothing changes in the latter's absence. It won't have done if the platform was not created for him to stand upon and survey the motions of his fellow Decepticons scheming below him.

Photographing this piece was a challenge due to the height of it exceeding the size of the photo booth we have!

===

This towering (heh heh) piece assembles together rather simply, comprised of 3 different zones:

• Tower Lower - 2 parts which connects atop the Space Bridge Elevator with a special connector piece

• PlatformLevel - Made up with a short tower segment , to which 4 Platform Braces are attached to using 5mm pegs. The horizontal platform is then put together using 4 large segments and 4 small segments to rest on top of the brace pieces

• TowerUpper - The geometry of these 2 parts are similar so basically they can be in stacked in any order to extend upwards (indefinitely). Make it as tall as you like!

===

Yes, this took a while due to the size but will work well combined with other CyberBase System parts so you can start to deck out your Deception Diorama or Display! We'll need to get more of the base tiles out but you can check out some of the photos attached to this post to get a sense of the possibilities too =)

As always, do have a ton of fun 3d printing this project out! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios