MK4 Golf R32 4 Inch Maf Sensor

This model was designed for people who run 4inch intake systems on their R32 Mk4 Golfs (this may also fit other mk4 golfs, please check your fitment. People generally use 4Inch systems when running cold air intake or supercharger/turbocharger set ups.
PLEASE NOTE THIS IS FOR EXPERIENCED USERS ONLY. THIS PART REQUIRES ASA or NYLON INFUSED CARBON FIBRE FILAMENT. You could try CF ABS or other filaments, but these are at your own risk due to GT/Melting temps, I feel they wouldnt last long in the hot conditions under the Bonnet/Hood.

This is ideal for any hobbist out there who has a modified mk4 r32 golf out there, who doesnt want to pay big prices for one.
£20 (STL cost)
£25-60 for reel of material

If you do your research you will find that this beats other companies out there in price, if you print it yourself. I'm a firm believer in being able to produce your own 3d printed products for a fraction of the price, given you pay for the file! :)

Please refer to your basic setup settings for ASA Filament or CF Nylon Filament.

Both to be printed with mesh side on bed, supports from base and also further if wanted; I used it at 35 degrees (CURA). Also infill is 70% or higher.

CF Nylon.
Extruder Temp.: 245°C - 275°C (Material Dependant) Full Metal Hot End Required. Hardened Steel Nozzle Needed.
Bed Temp:65-80C
Speed: 30-60 mm/s
0.2 mm - 0.4 mm layer heights
0-10% Layer Cooling Fan
(Enclosure Preferred to stop warping)

ASA Settings
Nozzle:220-250
Bed:85-110
Print Speed: 20-40mm/s
0.2-0.3mm layer
0-10% Fan
Can be printed without enclosure