Ultimate Mac Mini Wall Mount Case Fits M2!

Here's the ultimate Mac Mini wall mounting system!
Easily mount your computer securely & safely to any wall or surface, horizontal or vertical! It fits any Mac Mini with the modern form factor, including the new 2023 M2 Mac Mini's!!
Tested with 2014 & 2023 M2 computers.

The unit is a fully captured system that has a slide locking lid that sits 1mm off the top of your computer so not to scratch it when being applied or removed. No bolts or screws required!
NOTE! Depending on your printer's accuracy & setup you may need to slightly sand or file the lid tabs until you get an easy & smooth fit to the main body. DO NOT FORCE the lid on or you'll break the prints. Also a quick (!!!) flash with a blue flame wind proof lighter to smooth & soften the lid tabs does wonders! This is because tolerances are very tight!

Also the unit is designed to accommodate paper or thin card fillets around the edges of the computer to protect the finish of your machine & not allow the print to scuff or scratch the brushed aluminium faces of your computer! Nothing worse than ruining the clean finish of a Mac! Simply cut some paper or card & slip it down between the print & the side of the computer - the case was designed for this.

The unit boasts large port & power button access on top with a lip that hides the rear face of the computer so to keep the design aesthetics.

4 Large hidden & recessed mounting screws holes are available.

The unit's base is contoured to the shape of the underside of the Mac Mini with an increasing pitch towards the centre which allows airflow into & around the base of the computer.

There's also 9 angled air channels in the unit's footprint to allow maximum airflow up into the base of the computer to keep cooling as effective as possible! The black base of the Mac is fully open & suspended!!

The large circular cutout on top also allows for additional cooling.

Any problems or issues contact me & I'll do my best to help you.

250x250 bed size or larger recommended (240 doable)
PLA+ recommended.
0.2-0.3mm layer height on a 0.4-0.6mm nozzle
3-4 walls
5 layers top & bottom
15% gyroid infill