This is the Shaded castle from elden ring, but it is a dicetower! With two exit, one to the greater yard, and one to the smaller one.
This model is cut up into 10 parts, and you have to glue them together, except the inside of the tower and the roof of the tower.
Biggest part in one H7 cm x W16 cm x D16 cm H2,7inchx W6,2 inch x D6,2 inch
Whole Size H17 cm x W26 cm x D26 cm H6,7inchx W10,2 inch x D10,2 inch
Printing settings: It prints mostly without supports. The only parts needed support were the bridges and the roof. I printed with 0.2mm layer height, and i think it's fine for the qualityof the models.