Replacement Tap Handle - Th3 B^ck-Up

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115140

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115141

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115142

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115162

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115163

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115164

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115165

Replacement Tap Handle - Th3 B^ck-Up 3D Print 115166

Prints (-1)

Description

Replacement Tap Handle for when you're in a jam - Th3 B^ck-Up.

Printed on an Ultimaker 2 Extended + | Sliced with Cura slicing software

Update 12 January 2018: model now solid (no multiple shells) due to some slicing software not being able to handle multiple shells.

Print settings:

No Supports / Print Bed Adhesion

TAP HANDLE :

Standard Fast Print : 60mm/s - Top/Bottom Speed 30mm/s - Travel Speed 150mm/s - Initial Layer Speed 30mm/s

In-Fill Density : 35% In-Fill Pattern : Grid

(play around with the In-Fill densitys, ! chose to print a 35% in-fill for two reasons 1) Time constraints. 2) The washers in the tap were still good and it didn't require much force to turn the water off. A denser in-fill should give you a stronger print.)

Build Plate Temp: 60Deg/C | printed in ColorFabb PLA / PLH @212Deg/C | 0.4mm Nozzle

HOT/COLD CAPS : I recommend printing the Hot and Cold Caps with a 0.25mm Nozzle at a suitable speed for that nozzle.

Boolean Operands were employed in the creation of this model.

Please remember material shrinkage will vary depending on material, brand and colour.

If you like any of my designs please show your support by sharing them with your followers on Twitter #3dprinting and uploading pictures of your prints. Happy printing.

D3V!rum3tM^ch!n^ @DVirumEtMachina